#PP619
PP619 CAN-Bus Test Box
#PP619
PP619 CAN-Bus Test Box
$522.00*
*15% GST applicable for sales within NZ
Product Description
- Plugs into vehicle's OBDII connector
- Allows easier diagnosis of electrical faults
- Instantly check power and ground circuits
- Identify communication link protocols
- Connect an oscilloscope for signal capture and collection of signal waveform data
The CAN Test Box allows you to connect your PicoScope oscilloscope, or any other compatible scope, enabling you to monitor any signals present, such as the CAN High and Low signals. The CAN Test Box terminal pin ports are accessible with standard 4 mm jacks.
The CAN Test Box includes a 2.5 metre cable so that you can work in a convenient location away from the diagnostic connector, and an additional pass-through connector so that you can hook up your scan tool at the same time as your scope. The box is powered by the diagnostic connector, so no batteries or mains adaptor are needed.
Optional Accessory
$78.00
How it works
The CAN Test Box uses numbered backlit LEDs which illuminate when signal data is present on the corresponding pin of the DLC. Pulsing LEDs indicate signals being pulled high/low. The LEDs indicate the following signals:
|